I just imported the new 2019 CDT codes and noticed a new category named "Cleanings" was created and D1516, 1517, 1526, 1527 all pertaining to space maintainers were added to this category.
I'm assuming this is an error, so wanted to point it out. Any recommendations to which category I should move these codes? Also, being that these are currently my only codes within this category, any recommendations for use of "Cleanings" category? Thanks.
2019 CDT Codes...Cleanings Category and Space Maintainers?
-
- Posts: 30
- Joined: Fri Nov 14, 2014 4:56 pm
Re: 2019 CDT Codes...Cleanings Category and Space Maintainer
I have them placed in the Ortho category.
Philip H. Doan, DDS
http://www.kaweahdental.com/
http://www.kaweahdental.com/
Re: 2019 CDT Codes...Cleanings Category and Space Maintainer
I'll have someone look into this. What version of Open Dental are you using?
The best thing about a boolean is even if you are wrong, you are only off by a bit.
Jason Salmon
Open Dental Software
http://www.opendental.com
Jason Salmon
Open Dental Software
http://www.opendental.com
Re: 2019 CDT Codes...Cleanings Category and Space Maintainer
Issue verified and added to our bug tracker.
https://opendentalsoft.com:1943/ODBugTr ... sions.aspx
https://opendentalsoft.com:1943/ODBugTr ... sions.aspx
The best thing about a boolean is even if you are wrong, you are only off by a bit.
Jason Salmon
Open Dental Software
http://www.opendental.com
Jason Salmon
Open Dental Software
http://www.opendental.com
-
- Posts: 30
- Joined: Fri Nov 14, 2014 4:56 pm
Re: 2019 CDT Codes...Cleanings Category and Space Maintainer
Version 18.3.37.0, although I see you've verified it already.
Thanks for the suggestion teethdood.
Thanks for the suggestion teethdood.
Re: 2019 CDT Codes...Cleanings Category and Space Maintainer
The bug "New 2019 procedure codes were sometimes getting set to the wrong category" has been fixed and will be released with v18.3.39 and v18.4.11
https://opendentalsoft.com:1943/ODBugTr ... sions.aspx
Note that once you are on this version, you will need to run the D-Codes tool to get the codes into the proper category.
http://opendental.com/manual/procedurecodetools.html
https://opendentalsoft.com:1943/ODBugTr ... sions.aspx
Note that once you are on this version, you will need to run the D-Codes tool to get the codes into the proper category.
http://opendental.com/manual/procedurecodetools.html