5.3.6 not able to print Rx?

chrijj · Post by **chrijj** » Thu Oct 04, 2007 8:42 am

I ve updated to version 5.3.6 and i m not able to print prescriptions anymore.

Is there anyway i can solve this problem?

also i ve been wondering which notes are listed on incomplete procedure notes report, it's always blank for me. where should i put the notes to appear in this report?

thank you very much

Post by **jordansparks** » Thu Oct 04, 2007 8:47 am

For the report, see the bottom of this page http://www.open-dent.com/manual/procedurecodeedit.html

chrijj · Post by **chrijj** » Thu Oct 04, 2007 10:37 am

thank you very much.

i've found also that i can't print treatment plan, i get a window with print preview the same that happens with Rx print option.

drtech · Post by **drtech** » Thu Oct 04, 2007 12:25 pm

Sounds like you compiled the source with the debug option on, that always goes to print preview. You must compile in the release mode.

chrijj · Post by **chrijj** » Thu Oct 04, 2007 4:01 pm

thanks again
sorry for that mistake i think it's the second time it happens to me... hope i've learnt it now.