Open Dental Forum

It is time to upgrade the computers and running into an issue with Gendex eHD Sensors and Windows 10. The official eHD sensor drivers on Gendex/Kavo site are for Windows7. We use VixWin for imaging software. Wondering if anyone has been able to get the eHD sensors working with Windows 10? Would hate...

Thanks for the reply Jason. I tried the fix suggested in Error: Mixed mode assembly section on: http://www.opendental.com/manual/sourcecode.html It did not fix my error, so I had to turn "Generate serialization assembly" to "Off" in the OpenDental Build. Then the Release mode compiles fine. Perhaps ...

Happy 4th !!! I am using XP SP3 (x32), VS2012 Ultimate and trying to compile OD ver 12.3.52. The debug build compiles fine, but the release version gives the following errors (compiling both in x86 mode): Error 22 Metadata file 'C:\OD_SRC_12_3_52\OpenDentBusiness\bin\Release\OpenDentBusiness.dll' co...

We are looking to buy a digital x-ray sensor for our small office. So far I have looked at: Dexis: Too expensive. :( EVA with ProImage SW: The quality was not too good. I think it has CMOS based sensor Gendix with Vixwin Platinum SW: Mid range with acceptable quality So we are leaning towards Gendix...

Any solution to this DLL problem.

I am planning to buy 2 HK-780 intraloral cameras from Ebay, but was wondering if anyone has been successful at integrating them with OD.

Thanks for your replies.