Creating a new eForm - unhandled input error.
Posted: Fri Nov 28, 2025 3:17 pm
When creating/editing a new eForm, a percent "%" symbol was accidently typed in the width field entry after the number. When going to save the form it pops up an ugly message and then OD shuts down completely, not saving any changes made for the last 15 minutes... Could be handled more gracefully 
Also tried it with "px" after the number to see if that would trigger it. It does.
On a related note, the reason changes weren't being saved more often is because when you do, OD takes you out of the eForm designer and you have to click the form again to continue editing it. Can there be two save buttons? One with "Save" that leaves you in the form editor and one that is "Save and Close" for when you are actually done.
updated: as you build out your form and it has multiple pages, when you save your changes and it takes you out of the editor, you have to click to open the form again, and then click as many times as needed to get back to the page you were working on to continue editing. It's not nice to work with.
Thanks!
Also tried it with "px" after the number to see if that would trigger it. It does. On a related note, the reason changes weren't being saved more often is because when you do, OD takes you out of the eForm designer and you have to click the form again to continue editing it. Can there be two save buttons? One with "Save" that leaves you in the form editor and one that is "Save and Close" for when you are actually done.
updated: as you build out your form and it has multiple pages, when you save your changes and it takes you out of the editor, you have to click to open the form again, and then click as many times as needed to get back to the page you were working on to continue editing. It's not nice to work with.
Thanks!