Open Dental Forum

I can launch the Schick/CDR program from the OD brigde but cannot pass PatientIDs to the program. I saw the note below in the OD Program Link interface for the Schick software:

"There is no path or command line for this link. It will simply recognize the Schick CDR DICOM program if installed."

Is it the reason why the program does not recognize the passed PatientID?

If anyone has bridged OD with Schick software please advise.

Thanks.

You just enabled the exisiting program link rather than creating your own from scratch, right?

Yes. I just enabled the existing schick program link.

I'd have to see the behavior on the screen to know what was going on.