OD12.3 - Could not load file or assembly 'SigPlusNET.dll

This forum is for programmers who have questions about the source code.
Post Reply
pna
Posts: 12
Joined: Mon Sep 27, 2010 4:44 pm

OD12.3 - Could not load file or assembly 'SigPlusNET.dll

Post by pna » Sat Oct 20, 2012 5:15 pm

While building OD 12.3 in release configuration, I get error: "Could not load file or assembly 'SigPlusNET.dll' or one of its dependencies. Access is denied". This error is produced by SGEN component. Interestingly, this error does not occur while building in Debug configuration. I am not a programmer, but I noticed that the error goes away when I turn "Generate Serialization Assembly" to off.

Has anyone encountered this error before? Will turning "Generate Serialization Assembly" to OFF, cause application to malfunction?

Thanks

User avatar
jordansparks
Site Admin
Posts: 5739
Joined: Sun Jun 17, 2007 3:59 pm
Location: Salem, Oregon
Contact:

Re: OD12.3 - Could not load file or assembly 'SigPlusNET.dll

Post by jordansparks » Thu Oct 25, 2012 7:02 pm

No, it will not cause any malfunction. It just causes it to run very slightly slower.
Jordan Sparks, DMD
http://www.opendental.com

Post Reply