Planmeca Twain Driver

For users or potential users.
Post Reply
manuva
Posts: 7
Joined: Mon May 18, 2015 4:02 pm

Planmeca Twain Driver

Post by manuva » Wed May 20, 2015 3:20 pm

Hi folks,

I am trying to work with an intraoral x-ray sensor: a planmeca Dixi3 sensor, attached to a Network Interface box. So far, I have been able to connect the sensor to the Network Interface box, and access boxe's web UI: i.e. able to change the IP address of the box and the port number.

I also configured my PC with the box's IP address and port, i.e. I ran the Didapi config exe and set it up.

Now I am stumped! I can not for the life of me, figure out how to get Apteryx to see this sensor. I think I need the Planmeca twain driver, i.e. get the sensor to show up on PC as a device.

Any idea where I can get the Twain driver for Planmeca? Appreciate any help & advice!
TIA,
Manu

User avatar
Justin Shafer
Posts: 596
Joined: Sat Jul 28, 2007 7:34 pm
Location: Fort Worth, TX.

Re: Planmeca Twain Driver

Post by Justin Shafer » Wed May 20, 2015 4:12 pm


manuva
Posts: 7
Joined: Mon May 18, 2015 4:02 pm

Re: Planmeca Twain Driver

Post by manuva » Thu Jun 04, 2015 1:22 pm

Thank you very much Justin! With your help, I did manage to get it to work.

Post Reply