Does anyone use open dental in portrait mode? Im wondering if I would be missing anything or have to do excessive side scrolling if i used it like that. I would use dual monitors at the 12:00 position, side by side, in portrait mode. This is because side by side horizontal would make the monitors stick out past the width of the cabinet they would be mounted on.
The resolutions are 1600X900, id run them @ 900x1600; whats the horizontal resolution of open dental? less than 900? if so then it should look just fine.
Alternatively I could stack them one above the other, but that would make visibility worse.
Portrait mode?
-
- Posts: 172
- Joined: Mon Aug 04, 2008 12:39 pm
Re: Portrait mode?
1024 x 768 is the minimum, so 900 x 1600 probably will not work, right hand side will be cut off. But just install trial version to see.
- jordansparks
- Site Admin
- Posts: 5746
- Joined: Sun Jun 17, 2007 3:59 pm
- Location: Salem, Oregon
- Contact: