I started using 5.0.15 in the office after testing it at home for a while. At the office the graphical chart on 3 computers is not acceptable (with or without OD hardware acceleration option). I'm trying to figure out why. All 7 computers are new Dells w/ have plenty of processor and 1Gb of ram. The only common thread I see in the non-working computers is the video card:
-2 computers w/ 128Mb ATI X300 video cards = work fine
-2 computers w/ onboard Intel shared graphics card= work fine
-3 computers w/ 128Mb Nvidia cards= don't work properly
I bought the Nvidia cards for dual monitor capability in the operatories, but now I have to use the simple tooth chart in the ops which is very tough.
Do I need to get new graphic cards or is there some other fix?
DrG
Graphical chart/ video card problems
Hello
Check out this thread: http://odent.freeforums.org/viewtopic.php?t=146.
Also, could it be the drivers?
It seem to be a bug, I'm not sure though.
I had a slow down problem but that was solved with the OD hardware acceleration option.
Check out this thread: http://odent.freeforums.org/viewtopic.php?t=146.
Also, could it be the drivers?
It seem to be a bug, I'm not sure though.
I had a slow down problem but that was solved with the OD hardware acceleration option.
One office has 5 dell optiplex 320 with ati card can't handle hardware acceleration. I set all to simple. One dell, for which I forgot the model number, has Intel built-in graphic, works great with hardware acceleration. I set that to simple too.
One office has 2 dell...forgot spec, run well with hardware acceleration. I set to simple.
I hope those offices run well with RDC, which I'll test tomorrow.
One office has 2 dell...forgot spec, run well with hardware acceleration. I set to simple.
I hope those offices run well with RDC, which I'll test tomorrow.